Burst Pipe in Wall Cleanup Cost Calculator
Enter the size of the wet area and what got wet to see a typical national price range for burst pipe cleanup and drying. It is an estimate only; the real price comes from the walkthrough.
Estimate the Cost
Typical range: $750 to $1,400
How it works: typical national figures of about $3.75 to $7 per square foot for clean water, $4.50 to $8.50 for gray water and $7 to $13 for black water, multiplied by 1.25 to 1.7 for drywall, ceilings, hardwood or finished basements and by 1.25 when the water sat for more than two days, with a small-job minimum. Pipe repair and rebuild are not included. Estimate only, not a quote.
Get the stud bays dried out (888) 509-1696
Cost of Burst Pipe in Wall Cleanup
Nationally, burst pipe in wall cleanup typically costs about $1,200 to $6,500 for one to a few wet walls, counting extraction, removal of wet drywall and insulation, and drying. Kitchen and bath walls with cabinets or tile, drain water and leaks that ran for weeks push the total higher.
- Single wall, found early: $900 to $2,800. Water in a few stud bays, lower drywall and batts out, the cavity dried.
- Wall plus the floor beside it: $2,500 to $6,500. Carpet, pad or hardwood in front of the wall soaked up water as well.
- Cabinet, tile or multi-room walls: $6,000 to $14,000. Kitchen or bath walls with cabinets pulled, or water that crossed into several rooms.
- Per square foot of affected area: $3.50 to $7.50. Clean supply water sits near the low end; drain water and long saturation near the top.
What changes the price
- How many stud bays hold water and how high the drywall wicked it.
- Exterior walls packed with insulation, compared with hollow interior partitions.
- What hangs on or sits against the wall: cabinets, tile, a tub surround or built-ins.
- How long the leak ran before anyone found it, and whether drain water was involved.